Convert to a surround sound system wireless

!±8± Convert to a surround sound system wireless

The surround sound is something that many people decide what they want in their homes. The problem is that they see that is ugly with lots of wires everywhere and can pose a real threat. So you want to convert to a wireless surround sound. Unfortunately I'm not sure how to do it.

If you know someone who makes regular surround system and I want to convert it into a surround sound system wireless at home, here are the steps to beSo your house sounds like a theater without all the wires.

The first thing to do is unplug the receiver from the mains. Then you have to cut some speaker wire into a length of twelve inches, destroying half inch of insulation of the cables at both ends of the lengths. There are about two of these lengths for each speaker, that he must go to the radio station you are connected with.

The next thingwant to do when you are converting to wireless surround sound speakers is the cable to connect posts on the back of the receiver for each of your wireless speakers. As an example, the rear speakers of surround sound is usually both on the system, the wireless LAN must be converted so that a piece of wire will be connected to the rear channel on the left side and right side, and you adjust the red wire to the corresponding post, connecting the other wire to the polethat is black,

Now you're going to do to connect the wires "other ends of the wireless transmitter supplied with the kit. The wires in the box where the transmitter is back with the spring clamps to lift the holes for the wires used in them can be combined to find out.

The next step in creating a surround sound without wires to connect smaller boxes for the receiver to the wireless speakers with speaker wire always the same methods described above. Then you want toThe speakers in the areas you want them to take and receive the receiver connected

At this point, you want the receiver and transmitter connected to the power source to connect again. Finally, turn on the receiver and make sure it says mode, surround sound speakers to test and verify that it is set to work.

Here are some tips to consider:

Be sure to connect the lines right, if you connectThe speakers, because you will find that the signal is reversed.

Make sure you're not connect something into something else before you have completed all connections to all.

It is not difficult to convert to surround sound without the wires until you follow the above steps.